Quality features for quality performance.
  Features
High-efficiency Copeland™ Compliant Scroll compressor with 10-year warranty.*
Rounded corners for safety and attractive, clean appearance.
Enhanced aluminum fins and copper tubing for high-efficiency and capacity.
Raised coil and cabinet prevent debris from collecting in coil and causing loss of airflow.
Filter drier for added protection and durability.
Reliable, solid-state, time-initiated, temperature terminated defrost system.
Service valves outside for easy servicing.
Baked polyester paint finish over galvanized steel for maximum durability.
Heavy-duty wire guard protects recessed coil from damage.
Operating sound levels as low as 76 decibels.
Low pressure switch for system protection.
Suction line accumulator for system protection.


Quality features for quality performance.
  Feature Benefit
No-weld, crimped 409 stainless steel S-curve primary heat exchanger, covered by a Limited Lifetime Warranty.* Longer life with no welds to break. Highly corrosion-resistant. Efficient, quiet operation - no "creaking". Non-prorated means full part replacement for length of warranty.
29-4C super high-grade stainless steel secondary heat exchanger covered by a Limited Lifetime Warranty.* Corrosion-resistant; extracts additional heat and injects it into the airflow for added comfort. Non-prorated means full part replacement for length of warranty.
Aluminized steel in-shot burners with sound reducers. Smooth, efficient light off, quiet operation, and reliable combustion efficiency.
2-stage gas valve. Allows furnace to operate at high or low output settings to more accurately and efficiently control your home's comfort in relation to outside temperature and heat loss.
Heavy-duty, 2-speed induced draft motor with stainless steel shaft, ball bearings and fan cooling. Matches power venter to heating output. Durable and reliable, for years of trouble-free service.
Variable Speed Fan Motor matches airflow to ductwork. Provides computer-controlled ramp up/ramp down air flow for improved efficiency, reduced noise and greater comfort.
Reliable ignition system with self-diagnostics and LED readout. Reliable light-off of burners under all conditions; self-diagnostics constantly monitor system performance.
Durable, one-piece steel cabinet. Long-lasting, high-quality finish that resists scratches and rust.
Fully insulated cabinet and blower compartment. Enhanced efficiency and quieter operation.
PVC or ABS exhaust. Field-proven safe, trouble-free and economical vent system; requires no chimney.


Quality features for quality performance.
  Features
No-weld, crimped aluminized steel heat exchanger with "wide chamber design".
20-year limited warranty on heat exchanger.
Durable, one-piece, pre-painted steel cabinet.
Fully insulated cabinet and blower compartment.
Beckett aluminized steel "in shot" burners with sound reducers.
Heavy-duty induced draft motor with stainless steel shaft and fan cooling.
Solid state integrated control board with A/C relay, plus terminals for adding an electronic air cleaner, humidifier and twinning two furnaces.
Continuous low-speed fan capability for electronic air cleaner.
Honeywell SmartValve™ System Control increases unit reliability, integrating ignition and gas control functions.
 

The most advanced heater you can own for pool, spa... or both!
  Features
Outdoor stack shields out wind. Suitable for high wind conditions. Also available with indoor drafthood.
EconoTherm inline 9-tube heat exchanger delivers highest heat transfer and efficiency. Stainless steel tube sheet provides superior corrosion resistance.
Controls located for convenient operation. Factory installed dual solid state electronic temperature thermostats.
Right side plumbing easily reversed for left side installation. Inlet/ Outlet connections accept 2" plumbing for the highest water flow in industry. Independent flanges for direct connection to 2" CPVC or PVC pipe will simplify installation and service.
UniTherm Plus flow regulator system controls both water temperature and flow rate through heater to prevent condensation, sooting and scaling.
Capron® Resin headers are designed for easy inspection and servicing and provide 100% corrosion free waterway. Threaded plugs are provided for drainage, thermostat well and UniTherm Governor.
Water pressure switch insures heater operates only when the filter pump is operational. Self drain feature eliminates winterizing requirement for pressure switch.
Slow opening gas valve assures smooth turn on. Choice of easy-light standing pilot with 100% shutoff - or electronic ignition.
Stainless steel burners are corrosion-free, long-lasting.
Fibreboard tile combustion chamber 1-1/2" thick improves fuel efficiency, resists damage and reduces heater weight for easier installation.
Superior corrosion resistant jacket and base materials, and impervious baked enamel finish... looks new for years.
 

Gas-fired induced draft water boiler.
  Feature Benefit
Economical Energy Efficiency
Electronic Ignition Reduces gas consumption, since fuel is burned only when heat is required.
Thick Fiberglass Insulation Baked enamel finished steel jacket is amply insulated, which reduces off-cycle heat loss and saves on fuel costs.
Induced Draft Combustion Inducer fan optimizes flue gas velocity through the boiler for greater heat transfer and higher efficiency.
Quality Construction, Built to Last
Cast Iron Heat Exchanger Cast iron is extremely durable and will provide years of reliable service.
Titanium Burners Provides greater resistance to corrosion and oxidation than competitive stainless or aluminized steel burners.
Sealed Ball Bearing Fan Provides greater reliability and quieter operation.
Attention to Detail
Pressure Switch Proves that the flue is clear and safe for venting, eliminating potential hazards.
Extra Fuse Link Provided with the boiler, so an inexpensive repair part doesn't keep you without heat.
Additional Features
Warranty Twenty-year limited heat exchanger warranty with non-prorated coverage. One-year limited covered parts warranty.
Wide Range of Sizes Comes in six sizes and is designed to fit almost any home's unique installation requirements.
Unit Test Every unit is fire tested prior to shipping for quality assurance.

Scottish Gas Group Inc.
585 Middlefield Road, Toronto, Ontario M1V 4Y5

Tel (416) 412-4424 Fax (416) 412-1487

Designed & Maintained by